English
What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.
| PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
| |
The power does not turn on. | The fuse has blown. | After checking for short circuits in the cables, replace the | |
|
| fuse with one having the same rating. | |
|
|
| |
| No ACC position on vehicle ignition. | Connect the same cable to the ignition as the battery cable. | |
|
|
| |
No sound can be heard, or the | The Attenuator function is turned on. | Turn off the Attenuator function. | |
volume is low. |
|
| |
The fader and/or balance settings are set all the way to | Reset the fader and/or balance settings. | ||
| |||
| one side. |
| |
|
|
| |
| The input/output cables or wiring harness are connected | Reconnect the input/output cables and/or the wiring harness | |
| incorrectly. | correctly. See the section on "Connecting Cables to | |
|
| Terminals". | |
|
|
| |
| The cassette tape is bad. | Try playing another cassette tape. If no problem is experi- | |
|
| enced, the first tape was bad. | |
|
|
| |
| The cassette tape is not loaded properly. | If the tape does not start to play when a cassette tape is | |
|
| inserted, eject it and try inserting it again. | |
|
|
| |
Nothing happens when the but- | The computer chip in the unit is not functioning normally. | Press the reset button on the unit (see page 3). | |
tons are pressed. |
|
| |
|
|
| |
The sound quality is poor or dis- | The tape head is dirty. | Clean the tape head, referring to the section on "Cleaning | |
torted. |
| the tape head" (see page 3). | |
|
|
| |
| A speaker cable may be pinched by a screw in the car. | Check the speaker wiring. | |
|
|
| |
| The speakers are not wired correctly. | Reconnect the speaker cables so that each output terminal | |
|
| is connected to a different speaker. | |
|
|
| |
Radio reception is poor. | The car antenna is not extended. | Pull out the antenna all the way. | |
|
|
| |
| The antenna control cable is not connected. | Connect the cable correctly, referring to the section on | |
|
| "Connecting Cables to Terminals". | |
|
|
| |
The memory is erased when | The battery cable has not been connected to the proper | Connect the cable correctly, referring to the section on | |
the ignition is turned off. | terminal. | "Connecting Cables to Terminals". | |
|
|
| |
| The ignition and battery cable are incorrectly connected. | Connect the cable correctly, referring to the section on | |
|
| "Connecting Cables to Terminals". | |
|
|
|
— 16 —