Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle.
KENWOOD disc changer control input
NOTE
To connect the Disc changer, consult your Disc changer manual.
Fuse (10A)
Wiring harness (Accessory1)
P.CONT | Power control/Motor antenna |
ANT. | control wire (Blue/White) |
CONT. |
|
• L
Rear left output (White)
Rear right output (Red)
FM/AM antenna input
White/Black
To front left speaker
Ignition key switch
Car fuse box (Main fuse)
Battery
ACC | If no connections are made, do not let |
| the wire come out from the tab. | |
| Car fuse |
| box |
| Ignition wire (Red) |
| Battery wire (Yellow) |
| Ground wire (Black) · (To car chassis) |
| 2CAUTION |
REAR • R REAR • L FRONT • R FRONT
White
Gray/Black
To front right
speaker
Gray
Green/Black
To rear left
speaker
Green
Purple/Black
To rear right
speaker
Purple
2WARNING
If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.
When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal.