Other features (See page 7)

Audio Control SettingAdjust various parameters of sound quality.

1Press the AUD button to enter the control mode.

Each time the AUD button is pressed, the adjustment mode display changes as follows:

7Bass 7Treble 7Balance 7Fader 7Volume

If you do not move to step 2 in 5 seconds, the unit will switch back to the volume adjustment mode (i.e., the normal mode).

NOTE Source tone memory

Each source (tape, FM, AM, and disc changer) has its own memory in which to store the bass and treble tone settings.

The settings made for a particular source are then recalled automatically whenever you use that source (e.g., FM mode uses the tone settings made for FM, AM for AM, etc.).

2Press the d/ubuttons to adjust the mode shown in the dis- play.

Use the following table as a guide for adjusting the settings in each mode.

Adjustment

Operation of Audio control button

mode

 

 

(Display)

dbutton

ubutton

Bass

Bass decreased.

Bass increased.

(“BAS”)

 

 

 

 

 

Treble

Treble decreased.

Treble increased.

(“TRE”)

 

 

 

 

 

Balance

Left channel empha-

Right channel empha-

(“BAL”)

sized.

sized.

 

 

 

Fader

Rear channel

Front channel

(“FAD”)

increased.

increased.

 

 

 

Clock DisplayDisplay the time.Switching to Time Display:

Press the CLK button repeatedly until the clock is displayed.

Adjusting Time

When the RDS station tuned into is transmitting a time signal, have the unit’s built-in time adjust automatically to the correct local time.

Adjusting the Time:

Tune into an RDS station for 3 or 4 minutes.

The time adjusts automatically to the correct local time.

NOTE

•The displayed time cannot be set manually, but only through RDS station time signals.

•The time is not adjusted when the RDS station you are tuned to is not transmitting a time signal. Choose another RDS station in such a case.

Function of the KRC-259R,159RA/RG,21R

TEL Mute Function

1

Shut down the audio system temporarily whenever an incoming call is received.

NOTE

The function will not work if a cable is not connected to the car phone.

When the telephone rings:

When a call is received, "CALL" is displayed and all the unit functions are temporarily interrupted.

Restoring Original Unit Source During Phone Call:

Press the SRC button.

"CALL" disappears from the display, and the volume of the original source is restored gradually.

Turning TEL Mute Function Off After Phone Call:

Hang the phone up.

"CALL" disappears from the display.

The original source (i.e., the one used before the phone call) is returned to automatically, and the volume restored gradually.

— 21 —