Normal playback
10 |
| ON/STANDBY |
|
|
|
|
| |||||||
POWER |
|
| SPEAKERS A B | INPUT SELECTOR | ||||||||||
|
|
|
| MULTI CONTROL | VOLUME CONTROL | |||||||||
|
|
|
|
|
|
| BALANCE | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to be used.
A ON : Sound from the speakers connected to the SPEAKERS A terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAKERS B terminals on the rear panel.
Operations
SOUND | SOURCE DIRECT |
| AUTO |
| POWER |
VOLUME UP, DOWN | S. DIRECT |
SOUND | MUTE |
BALANCE | |
BASS BOOST | MULTI CONTROL |
| |
| INPUT SELECTOR |
Preparing for playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1Turn on the POWER key to ON.2Turn on the power to this receiver by pressing ON/ STANDBY (
) key.Selecting MD/TAPE 1 (Main unit only)
Select the source name corresponding to the component connected to the MD/TAPE1 jacks. The initial factory setting is “TAPE 1”. To change the source name associated with the MD/TAPE1 jacks to “MD”, follow the steps below:
1Use the INPUT SELECTOR knob to select “TAPE 1”.2Hold down the AUTO key for more than 2 seconds.•The source indication changes to “MD”.
•To return to the original indication, repeat the above procedure.
A+B ON : Sound from both the speakers connected to the SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting
when listening with headphones.
The indicator for the speakers you want to use should be lit.
SP. A B
Listening to a source component
1Use the input selector (INPUT SELECTOR) to select the source you want to listen to.
The input sources change as shown below:Selecting a source using the INPUT SELECTOR1 TUNER (frequency display)2“CD”3“TAPE 1” or “MD”4 “PHONO”5 “AUX”•When selecting an input source by using the remote control , press the desired input selector key.
•The INPUT SELECTOR on the front panel of the receiver always cycles through all inputs.
2Start playback from the selected source.
3Use the VOLUME CONTROL (VOLUME UP , DOWN) to adjust the volume.
•The sound of input source cannot be listened to with TAPE2/MONITOR is ON.