Recording
12 | MULTI CONTROL | INPUT SELECTOR |
|
TAPE2/MONITOR function
Operations
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| SOUND |
|
|
|
|
|
|
|
|
|
|
| TAPE2 /MONITOR | |
|
|
|
|
|
|
|
|
|
|
| ||||
MULTI CONTROL
SOUND 
TAPE2 /MONITOR
INPUT SELECTOR
Recording audio
Recording a music source
1 Use the input selector (INPUT SELECTOR) to select the source (other than “TAPE 1”) you want to record.
2Set the cassette deck to record.3Start playback, then start recording.Copying tapes
TAPE 1 = TAPE 2 copying1Use the input selector to select “TAPE 1”.2Start playback on the cassette deck connected to the MD/TAPE1 jacks and start recording on the cassette deck connected to the TAPE2/MONITOR jacks.
•To copy tapes using a double cassette deck, refer to the instruction manual of the double cassette deck.
You can connect a cassette deck or graphic equalizer to the TAPE2/MONITOR jacks of the receiver. If a graphic equalizer is connected, the TAPE2/MONITOR key should be left in the on position. Alternately, if a cassette deck equipped with a
•The equalizer effect can be applied to the played audio but cannot be recorded together with the audio signal.
•Copy from “TAPE 2” to ”TAPE 1“ is not possible.Input level adjustment
(when using the monitor function)
If the input level while using the monitor function is too high, adjust the input level as described below.
The input level cannot be adjusted when in the source direct playback mode.
1Press the TAPE2/MONITOR key.2Press the SOUND key several times until the “INPUT” indication appears.3Use the MULTI CONTROL to adjust the input level.SP. A B
TAPE 2 / MONI FW INPUT - 6
•The adjustment mode is displayed for approximately 8 seconds.
•The input level may be adjusted to any one of 2 settings: 0 and