21 EN
Recording

Recording audio (analog sources)

Recording a music source

1Use the INPUT SELECTOR knob to select the source (other than
“MD/TAPE”) you want to record.
2Set the MD or TAPE recorder to record.
3Start playback, then start recording.

Recording video

1Use the INPUT SELECTOR to select the video source (other than
“VIDEO1”) you want to record.
2Set the video deck connected to VIDEO 1 to record.
• Select the REC MODE to record a digital input source.
3Start playback, then start recording.
• Recording may not be normal for some video software. This is due
to the copy guard condition. ‹

Recording audio (digital sources)

Switch on the REC MODE to record a digital input source.
Usually use the A-REC (Auto-Record) MODE to record audio input
sources. When the digital mode changes during recording in the A-REC
MODE , the audio input source may be interrupted momentarily.

Recording music in A-REC or M-REC mode

INPUT SELECTOR
DIMMER
1Use the INPUT SELECTOR knob to select the source [CD/DVD,
DVD or DVD/6CH (VR-615/KRF-V5060D only) or VIDEO2] you
want to record.
2Set the MD or TAPE recorder to record.
3Press and hold the DIMMER key for more than 2 seconds to select
the A-REC or M-REC mode during digital input.
• The mode changes every 2 seconds as shown below.
1Rec mode off : The digital input record mode is switched
off.
2A-REC : The digital input signals (DTS, Dolby
Digital, or PCM) are identified
automatically and converted into stereo
signals that are ready for recording.
3M-REC :The input signal type at the moment this
mode is selected is held throughout this
mode.
For A-REC mode:
For M-REC mode:
4Start playback, then start recording.
•If the audio reproduction stops in the middle due to change in the
input signals, etc., press the DIMMER key.
INPUT SELECTOR
*5197/17-21/EN 26/03/2002, 2:52 PM21