Setting up the system
Make connections as shown below.8 When connecting the related system components, be sure to also refer to the instruction manuals supplied with the components you are connecting.
Do not connect the power cord to a wall outlet until all connections are completed.
| Microcomputer malfunction |
| |
Preparations | If operation is not possible or an erroneous display appears, even | ||
though all connections have been made properly, reset the micro- | |||
| |||
| computer referring to “In case of difficulty”. | ° | |
|
|
| |
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions, including projections) equal to, or greater than shown below:
Left and right panels: 10 cm, Rear panel: 10 cm, Top panel: 50 cm
Connecting audio components
Shape of AC outletsFor U.K.
For other countries
SYSTEM CONTROL jacks 0To AC wall outletThe receiver’s VIDEO 2/MONITOR jacks can be used in two different ways. Make the appropriate setting for the component connected to the jack when the receiver is turned on.
Use as a VIDEO 2 jackYou can connect a video deck or the like to these jacks and perform video playback and recording. The initial factory setting is “VIDEO 2” .
Use as a MONITOR jackYou can connect a cassette deck or the like to these jacks and make use of the deck’s monitoring function during recording. Alternately, you can connect a graphic equalizer to these jacks to apply compensation to the music signal.
To use the VIDEO 2/MONITOR jacks as MONITOR jacks, hold down the VIDEO 2/MONITOR key of the main unit for more two seconds so that the indication shown below appears.
REC OUT PLAY IN REC OUT PLAY IN
L
R
PHONO | CD | MD / TAPE | VIDEO 2 / MONITOR |
IN | OUT |
|
| Cassette deck or |
| |
| graphic equalizer | ^ | |
|
|
|
To use these jacks as MONITOR jacks, you must change the appropriate setting.
OUT
VIDEO 2/MONITOR
|
|
| MONITOR kHz | DOWNMIX | DSP | TUNED |
SP A B | L | R | FM | AUTO SOUND DIGITAL | AUTO | |
MUTE |
| SW | AM PRO LOGIC S.DIRECT MEMO. | |||
|
|
| MHz | STEREO | MONITOR | ST. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
•At the same time the setting is switched to “MONITOR,” the audio input source switches to tuner and the video input source switches to VIDEO 1.
•To switch the setting back to “VIDEO 2,” once again hold down the VIDEO 2/MONITOR key for two seconds or more.
•If you decide to use the VIDEO 2/MONITOR jacks as MONITOR jacks, make sure to delete the “VIDEO 2 (VCR2)” input from the preset
remote control | RC6 |
Notes
IN
OUT
OUT
Record player1.Be sure to insert all connection cords securely. If their connections are imperfect, the sound may not be produced or noise may interfere.
2.Be sure to remove the power cord from the AC outlet before plugging or unplugging any connection cords. Plugging / unplugging connection cords without disconnecting the power cord can cause malfunctions and may damage the unit.
3.Do not connect power cords from components whose power consump-
tion is larger than what is indicated on the AC outlet at the rear of this unit.
To use the receiver for video recording, connect a video deck to the VIDEO 2/MONITOR jacks.