21 EN

Listening to a source component

VOLUME CONTROL
VOLUME /
INPUT SELECTOR
Input Selector AV AUX
1
Use the Input Selector and AV AUX keys to select the
source you want to listen to.
Selecting a source using each key.
VR-6050/KRF-V7060D/V6060D
1“DVD/6CH”
2“CD/DVD”
3“AUX” or “PHONO” (for KRF-V7060D only)
4“TUNER”
5“VIDEO 1”
6“VIDEO 2”
7“VIDEO 3”
8“MD/TAPE”
9“AV AUX”
KRF-V6060D (for the U.K. only)
1“DVD/6CH”
2“CD/DVD”
3“PHONO”
4“TUNER”
5“VIDEO 1”
6“VIDEO 2”
7“VIDEO 3”
8“MD/TAPE”
9“AV AUX”
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME +/

-

keys to
adjust the volume.
Normal playback

Preparing for playback

Some preparatory steps are needed before starting playback.
INPUT MODEMD/TAPEPOWER ON/OFF
(KRF-V7060D/V6060D)
A SPEAKERS BPOWER ON/STANDBY
(VR-6050)
ON/STANDBY
(KRF-V7060D/V6060D)
Turning on the receiver
1Turn on the power to the related components.
2Turn on the power to this receiver by pressing the POWER
ON/STANDBY (for VR-6050) key or POWER ON/OFF and
ON/STANDBY (for KRF-V7060D/V6060D) key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO 2
or DVD/6CH jacks, make sure that the input mode setting is correct for
the type of audio signal to be used. 9
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
Hold down the MD/TAPE key for more than 2 seconds.
•The source indication changes to “MD”.
•To return to the original indication, repeat the above procedure.
Selecting the speaker system
Press the A SPEAKERS B key to select the speaker system to be
used.
A ON :
Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel. No sound will be heard from
the subwoofer.
A+B ON : Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when
listening with headphones for stereo sound in all playback
modes. The display segments are different depending on
the type of input signal.
The indicator for the speakers
you want to use should be lit.
L
SL S SB SR
CR
SP MUTE
OPTICAL 6CH INPUT
COAXIAL ANALOG 96kHzfs
CINE
M
ACTI
V
DSP
M
A B CLIP
AUTO DETECT
SW
LFE
•Selecting “6CH INPUT” by pressing the INPUT MODE key, whereby
“DVD/6CH” is the input source will cause SPEAKERS A to be selected
automatically.
•VR6050/19-27/EN 4/9/02, 4:54 PM21