18 EN
Normal playback

Preparing for playback

Some preparatory steps are needed before starting playback.

Turning on the receiver

1Turn on the power to the related components.
2Turn on the power to this receiver by pressing POWER ON/
STANDBY (for VR-707) or POWER ON/OFF and ON/
STANDBY (for KRF-V6070D) key.

Selecting the input mode

If you have selected a component connected to the CD/DVD, VIDEO2,
DVD or DVD/6CH jacks, make sure that the input mode setting is correct
for the type of audio signal to be used. 8

Selecting MD/TAPE

Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1Use the INPUT SELECTOR knob to select “TAPE”.
2Hold down the AUTO key for more than 2 seconds.
•The source indication changes to “MD”.
•To return to the original indication, repeat procedure 2.

Setting the speaker status

Press the SPEAKERS ON/OFF key to switch the speaker on or off.
AUTO INPUT SELECTOR
(KRF-V6070D)
POWER
ON/OFF
SPEAKERS
ON/OFF
ON/STANDBY
(KRF-V6070D)
(VR-707)
POWER
ON/STANDBY
5Repeat steps 3 and 4 to input the distance for each of the
speakers.
6Setup is complete when the EXIT indication appears.
•The speakers you have selected should appear on the display.
Confirm that all the speakers have been correctly selected.
7Press the SETUP key to exit the SETUP mode.

Input level adjustment (analog sources only)

If the input level of an analog source signal is too high, the CLIP indicator
will blink to indicate the source signal. Adjust the input level.
1Use the INPUT SELECTOR knob to select the source of which the
input level you want to adjust.
•You can store a separate input level for each input source.
2Press the SOUND key repeatedly until the “INPUT” indication
appears.
3Use the MULTI CONTROL knob or Multi %/fi keys to adjust the
input level.
•The input level may be adjusted to any one of three settings: 0dB,
-3dB, and -6dB. (The initial setting is 0dB.)
4Press the SOUND key again to return to the input indication.
The speaker indicator lights up.

Preparing for surround sound

*5330/16-22/EN 1/21/03, 9:56 PM18