Using Receiver

How Do I Adjust the LCD Display?

How Do I Adjust the LCD Display?

Using Remote Control unit under low light

When using Remote Control unit under low light, the back light of the LCD display can be turned on.

/8

• Press and hold the F.SHIFT key for more than 2 sec-

1

 

1

onds.

 

/7

 

 

 

 

The back light is turned on and off every 2 seconds of

1

2

3

4

5

6

holding.

7

8

9

+10

0

+100

 

10

11

12

If the is blinked, the back light cannot be turned on because the batteries are nearly exhausted.

Adjusting the contrast of LCD display

The contrast of the LCD display can be adjusted to improve the visibility.

1.Press the Music key or Movie key to display “Menu”.

2.Press the Menu (LCD function key 2) key.

3.Press the Setup (LCD function key 2) key.

4. Press the LCD cursor up/down (/) key to select “03. Contrast”, then press the Enter key.

5. Select the desired contrast with the LCD cursor up/down (/) key. The previous menu re-appears in about 3 seconds after the above operation.

How Do I Adjust the LCD Display?

Adjusting the brightness of receiver

When the ambient light is low, for example in the night, the brightness of the receiver’s display can be dimmed and LED indicators (DTS, 96k fs, HDCD, DOLBY DIGITAL, MPEG and D.R.I.V.E. only) can be disabled.

•Press the F.SHIFT =LISTEN M. (DIMMER)* keys. Each press of the LISTEN M. key switches the brightness as shown below.

1

Display/bright

Indicators/enabled

2

Display/dim

Indicators/enabled

3

Display/dim

Indicators/disabled

Selecting the display mode of receiver front panel

•Press and hold the LISTEN MODE key on the receiver for more than 2 seconds.

The displayed information is switched every 2 seconds of holding the key.

A: Connected Device

Input Type

DVD

AUTO

B: Input Terminal

Connected Device

VIDEO3 :

DVD

C: Listen Mode

 

DOLBY DIGITAL

 

"Input Type" is displayed only when a selector with digital input is se- lected.

When the input mode is PHONO, TUNER or AV AUX, the connected device and listen mode are displayed alternately.

*When an operation is described as [F.SHIFT =LISTEN M. (DIMMER) key], for example, press the F.SHIFT key and press the next key (the LIS- TEN M. (DIMMER) key in this case) within 8 seconds.

Receiver Using

42

43