41 EN
Remote control unit
Cause
•No setup codes registered for the respective
input(s).
•The remote control is set to a different opera-
tion mode.
•Batteries are exhausted.
•The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
•The audio cords and system control cords are
not connected properly.
•No software is loaded in the source component.
•An attempt is made to play a tape which is
being recorded in the cassette deck.
•The remote control has not been set to the
operation mode for the component you wish
to control.
Remedy
•Register a setup code at the respective input(s).
fl
•Press the source select keys or SOURCE
keys to select the appropriate operation mode.
•Replace with new batteries.
•Operate the remote control unit within the
controllable range.
•Connect properly referring to “Setting up the
system”.
•Place software in the source component you
want to play.
•Wait until recording has completed.
•Press the source select keys or SOURCE
key to activate the operation mode for the
component you want to control before
operation. fi
Symptom
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
In case of difficulty
•VR6060/35-44/EN 3/11/02, 8:55 PM41