Installation
Before fixing the speaker in its position, be sure to check the sound while it is connected preliminary.
Caution:
•Install in a location that does not come in the way of driving, getting in or out of the vehicle and movement inside the vehicle compartment.
•Fix the product firmly so that it will not be moved by vibrations or impacts during driving.
Fixing the cord in place
4 Machine screw x 2
3 Fixture C | 6 |
| |
| 9 RCA cord |
8 Remote control
(Fig. 1) | (Fig. 2) |
1Connect the
(The cords to be connected depends on the sys- tem. Refer to Connection of example.)
2Fix the cords to the speaker unit with fixture C 3, and fix in place with the machine screws 4. (Fig. 2)
ENGLISH
Fixing the subwoofer
Flat installation 4 Machine screw x 4 1 
1 Fixture A x 2
Caution:
This portion becomes slightly hot ter than other por tions because it functions as the radiator of the heat generated by the amplifier.
Attach the fixtures A 1to the speaker unit securely using the machine screws 4. Be careful so that the connected cords do not get in between the speaker unit and fixtures A 1.
Side installation
1
Holes not 
used 
4 Machine |
|
screw x 6 | Holes not |
2 Fixture | |
B x 2 | used |
Adjust the installation height so that the speaker unit will not rattle, and attach the bracket B 2to the subwoofer using the machine screws .
2
5 Tapping screw x 4
Drill four pilot holes for ø3.6 mm screws.
4
2
5 Tapping screw x 6
Drill six pilot holes for ø3.6 mm screws.
Drill the pilot holes for φ3.6 mm screws on the sheet metal section of the vehicle , and attach the speaker unit to the vehicle using the tapping screws 5.
2Fixture B x 2
Drill the pilot holes for φ3.6 mm screws on the sheet metal section of the vehicle, and attach the speaker unit to the vehicle using the tapping screws 5.
Installing the remote control unit
Install the remote control unit on the vehicle by the provided Velcro tape.
Vehicle
7 Velcro tape | 7 Velcro tape |
| |
(Softer surface) |
| ||
(Harder surface) | Rear panel | ||
|
Caution:
Install the remote control unit in a position that does not come in the way of driving operations.
Avoid installing it in a place subject to direct sunlight or direct hot wind from the heater. Otherwise, the product may be degraded and a fire hazard may result.
Remove dirt from the installation position before attaching the Velcro tape. When the Velcro tape is attached on the remote control unit, it cannot be accommodated in the main unit.
English