Installation

Connecting Wires to Terminals

Control Unit

Control Unit

(5L connector)

(KAB connector)

KTC-HR200

SELECT SWITCH

KAB Set "SELECT SWITCH" 1 depending on a connector type of a control unit to be used.

When connecting to the control unit with 5L connector, set this switch down,

5L and when KAB connector set the switch up (ON).

Installation

Accessory2

⁄

•The unit can only be connected to a control unit with either 5L or KAB connector.

Antenna Cable (Accessory1)

To FM/AM antenna

⁄

•Keep "SELECT SWITCH" 2 down.

If you set the switch up (ON), the unit does not operate normally.

•KAB Connector units

KVT-512, DDX512, DNX5120, DNX512EX, DDX812, DDX712, DNX8120, DNX7120 (As of April, 2008)

Accessory3

Carpet

Remove the backing from the velcro strips (Accessory3) and attach it to the bottom of the unit. Install the switching unit on the carpet.

¤

•Please do not install the unit near the dashboard, the rear tray, or other important components. Doing so could lead to injury or accident should the unit come off due to a shock and strike a person or an important component.

⁄

• Do not stick the velcro tape over the serial number.

English En-15