Help? Error
When the unit fails to operate correctly, the cause of the failure appears on the display.
Protect :
Protective circuit has been activated because a speaker cord has shorted or it has come in contact with the car chassis.
➡Wire or insulate the speaker cord as appropriate and then push the Reset button.
Hot Error :
When the internal temperature of this unit rises to 60°C or more, the protection circuit is activated and you may not be able to operate the unit. At such times this message will appear.
➡Use the unit again after reducing the temperature inside the vehicle.
Hold Error :
Activation of the protective circuit when the temperature inside the disc changer is higher than 60 degrees Celsius stops the disc changer from operating. At such times this message will appear.
➡Use when the temperature at the site where the disc changer has been fitted has dropped.
Mecha Error :
The disc player is malfunctioning.
➡Eject the disc and try inserting it again. Contact the Kenwood dealer if this indicator continues blinking or the disc cannot be ejected.
Disc Error :
An unplayable disc is inserted.
Read Error :
• Disc is quite dirty.
➡Clean the disc, referring to the section on
<Handling CDs> (page 8).
• Disc is upside down.
➡Load the disc with the labeled side up.
Region code Error :
The disc you wanted to play has a region code that cannot be played with this unit.
Parental level Error:
The disc you wanted to play has a higher level than the parental level you set.
Error
The unit is not operating correctly due to some reason or other.
➡Push the unit's Reset button. If the "Error 07−67" message does not disappear, see your nearest Kenwood dealer.
No Device (USB device)/Disconnected (iPod):
The USB device/iPod is selected as a source although no USB device/iPod is connected.
➡Change the source to any source other than USB/iPod. Connect an USB device/iPod, and change the source to USB/iPod again.
No Music:
The connected USB device contains no playable audio file.
Media was played that doesn’t have data recorded that the unit can play.
USB Device Error!!:
The connected USB device is rated a current capacity higher than the allowable limit.
➡Check the USB device.
Some trouble may have occurred to the connected USB device.
➡Change the source to any source other than USB. Remove the USB device.
Authorization Error:
Connection to the iPod has failed.
➡Remove the iPod and then reconnect it. The unit does not support the iPod.
➡Refer to <About iPod that can be connected to this unit> (page 7).
Update your iPod:
The iPod's software is an older version which the unit
can not support.
➡Confirm that the software for the iPod is the latest version. Refer to <About iPod that can be connected to this unit> (page 7).
EXT SW: Error:
Connection to the external device has failed.
➡Remove the external device and then reconnect it.
➡Turn off the power or ACC and turn it back on.
You can connect only one iPod:
More than one iPod are connected to this unit.
➡Disconnect all the iPods, and then reconnect only one.
100