Transmitting
To transmit, press and hold the P l T switch, then speak into the microphone.
The
. r .
When you have finished | releasethe PITswitch |
to receive. |
|
Impedance Selection
You can set the microphone impedance to 500 i2 or 50 ki2. Slide the 50W500 IMP. switch on the top of the microphone to your desired position.
Microphone Preamplifier
You can use this microphone with any KENWOOD transceiver. It has been designed especially for FM and SSB mobile transceivers. You can control the preamplifier using the MIC AMP INIOUT switch on the inside of the base of the transceiver.
First reniove the base of the microphone, then slide .the switch to tlie IN positionto turn the preamplifier ON.
With the switch in the OUT position, the preamplifier is bypassed and the batteries are disconnected. To conserve battery power, turn the preamplifier OFF when it is not in
.use.
With the switch in the IN position, the preamplifier is ON and the microphonecan be used with VOX operated equipment.
Oneral:ionWi3thouttheBaseStand
I
You can use the microphone without the base stand by connecting the microphone to the retractable cable, then directly to the transceiver. Doing so means you can no longer use the preamplifier,which is built info the base stand.
With a direct connection to the transceiver, you must use the ONIOFF switch located on the top of the microphone when you transmit. Slide the switch to the ON position to transmit, and to the OFF position to receive.
UPIDOWN Switcli
Use the UPIDOWN switch to select the transceiver's operating frequency. Refer to your transceiver instruction manual for further details on how to select an operating frequency.
Type:
Cornmunical:ion type dynamic microphone with P l T circuit.
Element:
Impedance:
Sensitivity:
Microphone
Preamp out
Preamp in
Frequency response:
Moving coil type, unidirectional
Dual impedance (1000 Hz) 50 ki2 f30%, 500 i2 f30% slide switch selectable
(0dB = 1 V/ pBAR, 1000 Hz)
MIC unit connection
Impedance
p (White) 1
(Green)
P.T. T
MIC stand connection MIC AMP
IN
Microphone or preamp off
Preamp on
Recorr~mendedoperating distance from microphone:
150 HZ - 10 kHz (-6dB)
200 Hz - 7 kHz
10cm (4inches) minimum
MIC cable connection
A
(Black)
(Shield)
(Yellow)