Kenwood MDX-F1 To stop playback, Tape counter display, To wind tape at high speed, Selection of reverse mode (Main unit only), Select, 2Select, 3Set it, direction

Contents

Playback of tape

25

To wind tape at high speed

To fast wind in	To fast wind in
direction	direction \
4	¢

0

To stop playback

STOP

0 7

Selection of reverse mode (Main unit only)1Select “TAPE RVS?” from the menu.

De

m o

MENU				SET
V			O	L
O
L			TR
U	ME		N
		/ MULTI	CO

Press the “SET/Demo” key while the “?” mark is blinking.

2Select.

“ ” : (REVERSE)
“ ”: (ONE-WAY)					“ ”: (ENDLESS)
V				O	L
O				R
L	U			T
		M	E/ MULTI	CO
3Set it.			D
			e
				m
			SET	o

Selection of TAPE EQ. (Remote control unit only)

TAPE EQ.

MDX-F1 (EN)

If you are operating the remote control unit, press the 1 or ¡ key.

1TUNING 1

÷Press the 7 key to stop fast winding.

÷Do not take out the cassette tape until the tape transport has stopped completely.

Tape counter display (Remote control unit only)

Each press of the TIME DISPLAY key changes the displayed contents.

			1 AM	0 0 0 0 (Tape count)
			2 AM	8 4 5 (Time display)
	The tape counter is set to “0000” when a cassette tape is
	loaded.
	By writing down the counter reading in case you want to
	interrupt recording (playback) in the middle of the tape,
	the memo will be helpful as a reference for locating the
	same position when continuing the recording (playback)				Operation
	the next time. The tape counter figure decrements dur-
	ing recording or playback of the back side (while the 2
	tape transport indicator is lit).
	To set the tape counter to “0000”, open the cassette
	holder once.
	Then the counter will be reset.
“ ” : (ONE-WAY)
			Only one side is played back (recorded), and then
			the tape stops.
“		” : (REVERSE)
			Both sides are played back (recorded), and then the
			tape stops. (Initial setup)
“			”: (ENDLESS)

Both sides are played back endlessly. (The tape stops after recording onto both sides.)

The tape stops after recording onto both sides.

The TAPE EQ. system minimizes the hiss noise heard when playing tape. When playing a tape prerecorded with Dolby NR ON, be sure to set the TAPE EQ. ON for playback.

Lit when “TAPE EQ.” is ON

TAPE EQ.

Each press switches the modes as follows.1 “TAPE EQ.” Light ......... TAPE EQ. is used.2 “TAPE EQ.” Goes off ... TAPE EQ. is not used.

÷ Select the TAPE EQ. mode according to the recording condition of the tape.