B. Time set
1.Select the CLOCK for which the time is to be set.
2.Press the TIME SET switch.
3.Simultaneously press the HOUR and MINUTE keys to stop the clock.
The colon on the clock display lights continuously, indi- cating that the clock has stopped and that you can now begin programming.
(Example)
4.Set the desired time using the HOUR and MINUTE keys. (Example)
5.Turn the TIME SET switch to OFF; the colon on the clock display starts blinking, indicating the new time.
Synchronizing your clocks to a known time standard such as WWV or JJY.
1.Set CLOCK 1 according to the instructions above.
2.Set the time of CLOCK 2 so that it is one minute ahead of the time you wish to begin.
For example, the present time is 5:59 UTC and you want the synchronization to begin at 6:00 UTC, so you would set CLOCK 2 to read 6:00.
3.To start the clock you would turn the TIME SET switch OFF in synchronization with the tone signal generated by the appropriate time standard. This will automatical- ly synchronize both CLOCK 1 and CLOCK 2 to the time standard.
Note:
An error of 1 minute between the minutes displayed on CLOCK 1 and CLOCK 2 may occur if both clocks are not displaying the same number of minutes, i.e. CLOCK 1 :59:00 and CLOCK 2:00:00 when you set
CLOCK 2.
You can program the
The time programmed with the ON TIME switch is used to turn the
1. Press the TIME SET switch.
2.Press and hold the ON TIME switch. The display will in- dicate:
(Example)
3.Set the desired time using the HOUR and MITUTE keys. (Example)
4.Release the ON TIME switch and the TIME SET switch.
5.Timer operation begins when the TIMER switch is turned ON.
Notes:
1.The timer will not function if the TIMER SET switch is left ON; be sure to turn the switch OFF after setting the timer.
2.If you simultaneously press the HOUR and MINUTE keys, the associated timer will be reset. (TIME ON or TIME OFF).
3.If you have not set either an ON time or an OFF time, nothing will happen when you press the TIMER switch.
4.When the TIMER is operating, a red asterisk (*) appears in the display.
5.When the TIMER is operating, the POWER switch does not function.
B. OFF TIME set
The OFF TIME turns the
1.Press the TIME SET switch.
2.Press and hold the OFF TIME switch; the display will indicate:
(Example)
3.Set the desired time using the HOUR and MINUTE keys.
4.Release the OFF TIME switch and the TIME SET switch.
5.Timer operation begins when the TIMER switch is turned ON.
C. ON/OFF operation
If both the ON time and the OFF time are set, the ON and OFF times are synchronized with CLOCK 1. The ON/OFF cycle is then repeated daily, as long as the TIMER switch in ON.
D. Checking the programmed times
To check the programmed times, press the ON TIME or OFF TIME switch.
Note:
You may check the times with the POWER swiltch ON or OFF, but you must program the TIMER with the POWER switch ON.
26