Congratulations!
The Kenwood Fineline™
Setting Up the Wireless System
RFU-6100
and degrade the system’s perform- | RF Receiver Connections |
ance. |
• To minimize interference, place | Left Surround | Right Surround | |
the RF transmitter away from | |||
Speaker | Speaker | ||
your A/V receiver and TV. |
|
| |
4. Connect the left & right surround |
|
| |
speakers to the RF receiver as |
|
| |
shown in the diagram to the left. |
|
| |
• Connect the terminal with the |
|
|
1. Connect the RF transmitter’s speaker wires as shown in the diagram to the right.
•Connect the wire with the blue lead to the A/V receiver’s Left Surround speak- er output’s “+” termi- nal; connect the wire with the gray lead to the A/V receiver’s
Right Surround speaker output’s “+” terminal.
NOTE: The transmitter can be used with A/V receivers with a sur- round channel power rating of up to 120 watts per channel. Use with surround channel power of more than 120 watts per channel may cause audible distortion.
RF Transmitter Connections |
|
Blue | Gray |
Wire | Wire |
|
|
blue lever to the left surround |
|
speaker; connect the terminal | Connect |
with the gray lever to the right | the speaker's "+" |
surround speaker. | (red) terminal |
to the receiver's | |
• Make sure to connect the “+” ter- | colored connector |
| |
minals on the RF receiver to the |
|
“+” terminals on the speakers. |
|
5. Place the RF receiver at least one foot off the ground. Avoid placing it close to large metal objects like radiators or heating/air condition- ing ducts. These objects can absorb RF signals and degrade the system’s performance.
• To minimize interference, place |
| |||||||
the RF receiver away from your |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
A/V receiver and TV. |
|
|
|
|
|
|
| |
RF Channel Selection |
|
|
|
| ||||
6. Make sure that the RF channel |
|
|
|
| ||||
|
|
| ||||||
|
|
| ||||||
switches on the transmitter and |
|
|
|
|
|
|
| |
receiver are both set to the same |
|
|
|
|
|
|
| |
channel (see the diagram to the right). |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
7. Plug the RF receiver’s AC cord and the RF transmitter’s power adapter into a wall outlet..
8. Extend the antennas on both units
2.Connect the supplied power supply adapter as shown in the diagram above.
Important: Do not plug the power adapter into the wall outlet until you have made all of the RF transmitter and RF receiver connections (Step 7).
3.Place the RF transmitter at least one foot off the ground. Avoid placing it close to large metal objects like radiators or heating/air conditioning ducts. These objects can absorb RF signals
If you have any questions about your new system, please contact our Customer Service Department at
(800)KENWOOD or visit our web site at www.kenwoodusa.com
as needed to improve reception.
9. If reception is poor or there is inter-
ference, change the RF channel on the transmitter and receiver as shown in the diagram to the right.
• Make sure both units are set to the same RF channel.
Kenwood Fineline™ Quick Start Guide
Copyright ©2004 Kenwood USA Corporation. All rights reserved. |