Kenwood TM-271A, TM-271E Performing Program Scan, Press Menu 1s to start MHz Scan

7Turn the Tuning control or press Mic [UP]/[DWN] to select a matching Memory Channel from U0 ~ U2.

¥For example, if you have selected ÒL0Ó in step 3, select Memory Channel ÒU0Ó.

8Press [MR] to store the end frequency in the Memory Channel.

■Performing Program Scan

1Press [VFO] and turn the Tuning control to select a frequency within the frequency range of Memory Channel L0/U0 ~ L2/U2.

2Press [VFO] (1s) to start Program Scan.

¥Scan starts from the current frequency.

¥The 1 MHz decimal blinks while scanning is in progress.

3Press any key other than [F] or [ ] (Power) to stop Program Scan.

Note:

◆The transceiver stops scanning when it detects a signal.

◆If more than 2 Program Scan channel pairs are stored and overlaps the frequency range among the pairs, the smaller Program Scan Memory Channel number has priority.

◆If the step size of the current VFO frequency is different from that of the programmed frequencies, VFO Scan begins instead of Program Scan.

◆To perform Program Scan, the ÒLÓ channel must be lower than the ÒUÓ channel. Otherwise, Band Scan starts {page 40}.

MHZ SCAN

MHz Scan allows you to scan an entire 1 MHz frequency range within the current VFO frequency.

1Press [VFO] and turn the Tuning control or press Mic [UP]/[DWN] to select a frequency in which to perform MHz Scan.

¥If you want to scan the entire 145 MHz frequency, select any frequency between 145.000 and 145.9975 MHz (for example, select 145.650 MHz). Scan will operate between 145.000 MHz and 145.9975 MHz. (The upper frequency limit depends on the current frequency step size.)

2Press [MENU] (1s) to start MHz Scan.

¥Scan starts from the current frequency.

¥The 1 MHz decimal blinks while scanning is in progress.

8

3Press any key other than [F] or [ ] (Power) to stop MHz Scan.

41