18Operation of remote control unit

XD-SERIES (En)

Loading batteries
1 Remove the cover.2 Insert batteries.3 Close the cover.

2

1

section

÷Insert two R6 (“AA”-size) batteries following the polarity indications.

Operation

Preparation

Plug the power cord into the mains power outlet and press

the on/standby ( POWER) key of the remote control unit to turn power ON. After the power has been turned ON, press the desired key.

To turn power off, press the on/standby ( POWER) key again. The system enters the standby mode in which only the time display is lit.

÷When pressing more than one remote control keys successively, press the keys securely by leaving an interval of 1 second or more between keys.

Remote sensor

6m

30˚ 30˚

Operating range (approx.)

 

1. The provided batteries are intended for use in operation checking, and their service life may be short.

Notes

2. When the remote controllable distance becomes short, replace both of the batteries with new ones.

3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.

 

In such a case, change the installation position to avoid malfunction.

Application section

Knowledge sections

CHANNEL SPACE setting

(Except for the U.S.A., Canada, U.K. Europe and Australia)

The space between radio channels has been set to the one that prevails in the area to which the system is shipped. However, if the current channel space setting does not match the setting in the area where the system is to be used, for instance when you move from area 1 or area 2 shown in the following table or vice versa, proper reception of AM/FM (SW/MW/FM) broadcasts cannot be expected. In this case, change the channel space setting in accordance with your area by referring to the following table.

 

Area

CHANNEL

 

SPACE freq.

 

 

 

 

 

1

USA, Canada and South

FM : 100 kHz

American countries

AM :

10 kHz

 

2

Other countries

FM :

50 kHz

AM :

9 kHz

 

 

1Turn power off.

ON/STANDBY

2Select the channel space.Each press switches the space frequency alternately.
1 “FM100/AM10 kHz” .......STEP,
2“FM 50 /AM 9 kHz” ....... STEP,

÷The “AM” display is variable depending on the model (country or area), and “MW” may be displayed in some areas.

FM10 0/ AM 1 0

FM 5 0/ AM 9

3Establish the selection.

ENTER