Kenwood 4.Select the source to be recorded, 5.Start recording, REC/ARM, To pause recording, Selection of the reverse mode, Selection of DOLBY NR (Noise Reduction)

Selection of the reverse mode

REV.MODE

Each press switches the modes as follows.

1 “[” ... Both sides are played back (recorded), and then the tape stops.

2“”” .. Both sides are played back endlessly. (The tape stops after recording onto both

sides.)

3““” .. Only one side is played back (recorded), and then the tape stops.

Let's record

XD-SERIES (En)

Selection of DOLBY NR (Noise Reduction)

The Dolby NR system minimizes the hiss noise heard when playing tape. When playing a tape prerecorded with Dolby NR ON, be sure to set the DOLBY NR ON for playback.

	Lit when “DOLBY NR” is ON.
DOLBY NR	TAPE B 0
	NR

Each press switches the modes as follows.

1 “1NR” ON ............. DOLBY NR is used.

2“1NR” OFF ............ DOLBY NR is not used.

31

section Preparation

4.Select the source to be recorded.

	The input source component to be recorded should be displayed.
	1 TUNER (Radio)
4	2 CD		CD 0 1	0 0 0
	3 TAPE
	4 AUX (External input)		1 2 3
	(AUX INPUT LEVEL adjustment o)
		÷When the CD input is selected and if a disc has
		been set in the CD player, its playback starts
Select an input source other than “TAPE”.		immediately.

5.Start recording.

REC/ARM	1Play (or tune) the input source to be	CD	0 1		0 1 2
	recorded.
	2Start recording.	1	2	3
5	÷Recording stops automatically when the tape
					Lights
	side(s) to be recorded have been fully recorded.

÷The beat cancel function can be used when

recording MW broadcasts. ¤

To pause recording

REC/ARM

÷Pressing the key pauses recording after leaving a non-recorded space of about 4 seconds. ÷If the key is pressed again in less than 4 seconds after it has been pressed, recording resumes

from that instant.

section Basic

section Application

sections Knowledge