Kenwood Copying tape, TAPE, FW D, D UB B, To stop dubbing, Copying tape (Tape dubbing), CD EDIT, CD RECORD, A DIR FWD, A DIR RVS, B DIR FWD, B DIR RVS, TAPE DUBBING

Copying tape (Tape dubbing)The contents of the tape in deck A can be copied onto the tape in deck B.

Let's record 33

XD-SERIES (En)

Load tapes in the decks.

1Select the “TAPE” input.

INPUT

2Select “[” (double-side recording) or ““” (one-side recording).

REV.MODE

3Press the DUBBING key.

DUBBING

4Select “TAPE DUBBING” and press the SET key.

1. Select. 2. Press SET.

MULTI

CONTROL

SET

5Use the same tape transport direc- tions.(1)Select the transport direction of deck A.

1. Select. 2. Press SET.

MULTI

CONTROL

SET

(2)Select the transport direction of deck B.

MULTI

CONTROL

6Start dubbing.

ENTER

Playing tape A A Recording tape

CD RECORD	Preparation
CD EDIT	section
CD PGM RECORD
TAPE DUBBING

				TAPE	D UB B I
				Scrolled display
				(TAPE DUBBING)		Basic
÷When recording is started, the tape will be transported in the direction
	selected in this step.
			Check the tape transport direction			section
			indicators.
		A DIR FWD
				A DI R	FW D
		A DIR RVS
		B DIR FWD
		B DIR RVS
		RETURN				section Application
÷By selecting “RETURN” and pressing the ENTER key, the operation
	returns to the previous step so the current step can be restarted.
÷Dubbing ends automatically when the side(s) to be dubbed has been
	completed.
To stop dubbing
				REC/ARM		Knowledge
	÷The deck B will stop after creating a non-recorded portion of about
						sections
		4 sec, and then the deck A will stop.
	÷Dubbing can also be stopped by pressing the stop (7) key. Note that
		the non-recorded space is not created in this case.

The DOLBY NR key is not active in dubbing mode. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on Note deck A.