English
— 62 —
Connecting Wires to Terminals
Make sure that the unit is installed securely in place. If the unit
is unstable, it may malfunction (eg, the sound may skip).
NOTE
Bend the tabs of the
mounting sleeve
with a screwdriver or
similar utensil and
attach it in place.
Metal mounting
strap
(commercially
available)
Self-tapping
screw
(commercially
available)
Firewall or metal support
Screw (M4X8)
(commercially
available)
Installation■Installation
Optical wire (Provided with the KDS-P901)
When handling an optical wire for
wiring, use care not to exceed the
minimum wire bend radius of 30
mm. If you exceed the minimum
bend limit, optical fibers within the
optical wire may be damaged.
When installing the DVD receiver
unit on the vehicle, ensure that the
optical wire is not stuck between
the DVD receiver unit and vehicle
parts.
2CAUTION
When only two speakers are being connected to the system,
connect the connectors either to both the front output terminals or
to both the rear output terminals (do not mix front and rear). For
example, if you connect the +connector of the left speaker to a
front output terminal, do not connect the -connector to a rear
output terminal.
2CAUTION
If you connect the ignition wire (red) and the battery wire (yellow) to
the car chassis (ground), you may cause a short circuit, that in turn
may start a fire. Always connect those wires to the power source
running through the fuse box.
2WARNING
Z910DVD(K)_U.S 02.12.13 6:43 PM Page 62