Adding Water
The LED Control Center of your Brewer will indicate when the water level in the reservoir is low or if the Water Reservoir has been removed by illuminating the blue light next to ‘ADD WATER’. The Brewer will not allow you to brew when the blue 'ADD WATER' light is illuminated.
ADD WATER
HEATING
DRAIN BREWER
POWER
BREW
PUSH TO BREW
The Water Reservoir can be filled in two ways.
1.Lift off the Water Reservoir Lid and pour water directly into the Water Reservoir while it is still attached to the Brewer, then replace the Lid.
2.Remove the Water Reservoir from Brewer by first removing Lid from Reservoir, then lifting Reservoir straight up and away from Brewer. Fill with water. Place the Water Reservoir back on the Brewer and replace the Lid.
3.The blue ADD WATER light will go out 3 seconds after installing or refilling the tank. This delay is normal.
IMPORTANT: Do not remove the Water Reservoir during the brewing process.
Draining the Brewer
The Hot Water tank of the B140 can be com- pletely drained. We recommend that the Brewer be drained if it is to be transported or stored for an extended period.
1. | The Brewer must be powered on and ready |
| to brew. |
2. | Empty the Cold Water Reservoir and place it |
4.Press and hold the Drain button. Water will start to flow from the vent nozzle into the Water Reservoir. It will continue to flow for as long as the button is depressed. Flow of water stops when the drain button is released.
CAUTION: The water may be very hot!
NOTE: The process to drain a Hot Water Tank from idle state takes about a minute.
5.Release the Drain button, when the flow of water stops. The brewer’s internal hot water tank is now empty.
6.Turn the valve to the ‘BREW’ position and turn off the brewer.
Brewing Hot Water
Your Brewer is able to produce a cup of hot water for making hot chocolate, for use in cooking, for making soups, etc. Simply raise and lower the handle on the Brewer without adding a
If you are experiencing any problems with your Brewer, please contact Customer Service at
SECTION 2
CONTROLS & INDICATORS
LED Control Center
Activating the Auto off Timer Feature
To set the Brewer to turn off two hours after the last brew.
a.Press the Power Button to turn on the Brewer.
b.Press the black button above the Power Button to turn the
back into the brewer. The add water LED will |
be flashing. |
3. Turn the Brew / Drain selector at the rear of |
the brewer to the “DRAIN” position. The |
green Drain light will be flashing to indicate |
that you may start draining the brewer. |
c.To turn off the Auto- Off Timer, simply press the black button again and the green light next to 'AUTO OFF' will turn off.
HEATING
DRAIN BREWER
POWER
BREW
PUSH TO BREW
8