Keurig B30 manual Cleaning & Maintenance, Holder Assembly, Cleaning the Hot Water Tank, Section

SECTION 2

CLEANING & MAINTENANCE

IMPORTANT: Make sure the brewer is unplugged before cleaning

Cleaning Drip Tray & External Parts

Regular cleaning of the Brewer’s external com- ponents is recommended using a damp lint-free cloth only.

1.Never immerse the base unit in water or other liquids. The Housing and other exter- nal components may be cleaned with a damp, non-abrasive, lint free cloth.

2.The Drip Tray can accumulate liquids. The Drip Tray and Drip Tray Plate should be peri- odically inspected and cleaned with a damp soapy non-abrasive lint free cloth. The Drip Tray and Drip Tray Plate should not be put into the dishwasher. To remove the Drip Tray Assembly, simply slide it toward you, keep- ing it level at all times to avoid spilling.

Cleaning the K-Cup®Portion Pack

Holder Assembly

1.Cleaning the Parts

The K-Cup®Holder Assembly is dishwasher safe. To remove from the Brewer, open the brewer by pressing the button. Grasp the top of the K-Cup®Holder with one hand while pushing up on the bottom of the K-Cup®Holder from underneath with the

K-Cup Holder

Assembly

K-Cup Holder

Funnel

other until it releases. After cleaning, align the K-Cup®Holder with the opening using the two front ribs as a guide and snap into place from the top.

2.Cleaning the Funnel

The Funnel can be removed from the K-Cup®Holder by pulling on it until it

snaps off. The Funnel is dishwasher safe. To replace it just snap it back onto the K-Cup®Holder Assembly.

K-Cup Holder

Insert paper clip here to clean out the exit needle

3.Cleaning the Exit Needle

The Exit Needle is located on the inside bot- tom of the K-Cup®Holder. Should a clog arise due to coffee grinds, it can be cleaned using a paper clip or similar tool. Remove K-Cup®Holder and then remove the funnel, insert the paper clip into the Needle to loosen the clog and push it out. The K-Cup®Holder is dishwasher safe. NOTE: The Entrance needle does not require cleaning.

CAUTION: There are sharp needles that puncture the K-Cup®above the K-Cup®Holder and in the bottom of the K-Cup®Holder. To avoid risk of injury, do not put your fingers in the K-Cup®Chamber.

When finished cleaning, reassemble the K-Cup holder and funnel and replace in the brewer. Close the brewer, the water fill lid will pop open.

NOTE: Over time, discoloration, spotting or staining may appear in the Hot Water Tank. This is normal and will vary depending on the miner- al content of the bottled or filtered water used in the brewer and will not affect the operation of the brewer.

Cleaning the Hot Water Tank

To access the Hot Water Tank, press the PRESS TO OPEN button and then lower the handle completely, the water fill lid will pop open. Inspect the Hot Water Tank area and clean with a damp lint free cloth as necessary. Close the water fill lid when finished.

3