Assembly
Assembly requires the included Allen wrench and Phillips screwdriver. Leave the unit on the original packing material to assemble all parts.
Do not plug in the power cord until all assembly steps are completed.
1.Remove top cover of box, and break the sides of the box to create a level assembly surface. After opening the box, remove any packing material from the treadmill. Carefully cut the strap sur- rounding the treadmill, only while the
treadmill is laying flat.
Do not remove unit from box until it has been fully assembled.
2.Locate the left upright. Connect the console harness together. One side of harness is located near the motor cover on the bottom left side. The other end is located inside the left upright.
Note: Make sure that the console har- ness is inside of the upright and not being pinched.
Slide the left upright onto the base frame.
Secure the left upright to the base frame by using four bolts M10x25 and four wash- ers 10.
Note: Do not tighten hardware until step 5 has been completed.
Figure 1: Unpacking Treadmill
Left Upright |
Bolt M10x25 |
Washer 10 |
Console |
Harness |
Base Frame |
