Assembly
4.Feed the wires coming out of right side of the console through the hole located on the tube of the right handlebar. Connect the amplifier wire coming from the handle- bar to the amplifier wire coming from the console. Connect the EKG harness and the toggle harness coming from the handlebar to the EKG harness and the toggle harness coming from the console. Secure the right handlebar to console using two bolts M8x52 and two washers #8.
Feed the wires coming out of the left side of the console through the hole located on the tube of the left handlebar. Connect the EKG harness and the toggle harness com- ing from the handlebar to the EKG harness and the toggle harness coming from the console. Secure the left handlebar to con- sole using two bolts M8x52 and two wash- ers #8.
NOTE: Make sure not to pinch or screw through any wires when securing the left handlebar.
6.Connect the console harness together. One side of harness is coming from the right upright. The other end is coming from the console.
Attach the console onto the uprights by sliding into the uprights.
NOTE: Make sure that the console har- ness and amplifier harness are inside of the upright and not being pinched.
Secure the console to the uprights using two bolts M10x25 and two washers #10 per side.
IMPORTANT PLEASE NOTE:
Tighten all hardware installed in Step 2 through Step 6.
Bolt M8x52 |
|
| |
|
|
| Washer #8 |
EKG | Toggle |
|
|
Harness |
| Console | |
Harness |
| ||
|
| Harness | |
|
|
| |
|
|
| Amplifying |
|
|
| Wire |
|
| EKG | Toggle |
|
| Harness | |
|
| Harness | |
|
|
| |
Figure 5: Console Assembly
Console |
|
Washer #10 | Console |
Harness | |
Amplifier |
|
Harness |
|
Bolt M10x25 |
|
Figure 6: Securing Console Assembly to Uprights
8
