Assembly
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
15 | 2 |
30
14 
18
10
1
45
44 41
43
14
3
44
STEP 1:
39
41 18
Place the left (#1) and right (#2) uprights on the floor as illustrated. The brackets welded down the side of each upright should be to the inside and facing each other.
Attach each end of the cross bar (#3) to the front of each upright with two bolts M10x90 (#39), four washers 10 (#15) and two nylon nuts M10 (#10). Install a rectangular reinforce- ment plate (#18) behind each upright during this assembly.
Place the backrest adjustment bar (#10) between the uprights so that the short pin at each end of the backrest adjustment bar is seated into the hole in a bracket.
Push a weight storage tube (#14) into the hole in the angled brace behind each upright and secure from below with one bolt M8x20 (#41) and one washer 8 (#44).
6
