Kicker IX500.4 Model, External Fuse, Power/Ground Wire, KICKER Wiring Kit, remote turn-on, ≤24”

Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the amplifi er. Make the ground wire short, 24” (60cm) or less, and connect it to a paint-and-corrosion-free, solid, metal area of the vehicle’s chassis. Adding an additional ground wire of this same gauge (or larger) between the battery’s negative post and the vehicle chassis is recommended.

The IX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals from your car stereo’s source unit. A high-level signal can be run from the source unit’s speaker outputs to the stereo RCA input on the end panel of the amplifi er using the KICKER ZISL as shown (make sure you set the IX amplifi er’s input level switch to “HI”). Alternatively, the signal can be delivered to the amplifi er using the low-level RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to “LO”. Either input method will provide a low-level output signal at the RCA output, which effectively passes the audio signal to another amplifi er or component. Keep the audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a 90 degree angle.

source unit	core conductor	to amplifi er	KICKER ZISL
high-level speaker
outputs
+		OR	to amplifi er
–	shield		source unit high-level
			speaker outputs

Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. Install a second fuse within 18” (45cm) of the amplifi er. If you ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last wire disconnected from the amplifi er--just the opposite as when you installed it.

Model	External Fuse	Power/Ground Wire	KICKER Wiring Kit
	(sold separately)
IX500.4	1 x 50 Ampere	4 Gauge	PK4, CK4, ZCK4

					remote turn-on
					(see page 5)
AMP1			POWER		AMP1	AMP2 OUTPUT			AUTO	AMP2
								TURN ON
L+ L– R+	R–	GND	REM	+12V						L– R+	R–
									L+
						L	12V		DC AUDIO
								OFFSET
							FADER INPUT
									LEVEL
						R
BRIDGED							OFF		LO	BRIDGED
							ON		HI
≤24”											≤18”
(60cm)
											(45cm)

bare-metal	external fuse	12V
chassis ground
		battery

3

2011 IX 500.4 RevB.indd 3

10/12/2010 10:57:25 AM