Kicker KS6.2, KS65.2, KS5.2 manual Wiring Options, Installation, SOURCE UNIT or AMPLIFIER

Installation

Wiring Options

Wiring two KS-Series System Components to a single channel

Modern high performance system components have a lower DC Resistance than what used to be available. The Kicker KS-Series System Components are rated at four ohms and work with any source unit or amplifier designed to operate at a four ohm load. If you want to use two KS-Series System Components on each channel of your source unit or amplifier wire the system components in series--at the connection between the crossover and source unit or amplifier, as shown below in Figure 6. This will improve the sound quality, lower the total harmonic distortion and lessen the thermal load at the source unit or amplifier. This may prevent an amplifier from shutting down, due to over-current protection circuitry.

Figure 6

to Tweeter CROSSOVER CROSSOVER to Tweeter

		to Woofer
to Woofer	SOURCE UNIT or AMPLIFIER

to Tweeter CROSSOVER CROSSOVER to Tweeter

	to Woofer
to Woofer

	All specifications and performance figures are subject to change. Please visit kicker.com for the most current information.
10	KS-Series System Components