Installation
8.Hook the keyhole in the back cover over the screw head before or after replacing the back cover on the unit.
9.Plug the adapter into an unswitched wall socket.
Table Top Alarm
You can also use your Kidde CO Alarm as a table top unit. Simply fol- low the steps for removing adapter, then instead of mounting the alarm to a wall, replace the back cover and stand the unit on a table, bed- side stand, or chest of drawers.
Normal Operating Characteristics
When you first power up the unit, the alarm will sound briefly to let you know the unit is receiving power and that the alarm circuit is function- ing.
You should see three eights on the digital display, indicating the alarm is in the
Within 20 seconds, your CO alarm will start monitoring for CO.
Note: The number will probably be zero (0). This is a normal condition for most households and indicates that no measurable amount of CO is being detected.
The alarm has begun monitoring the air for CO and will continue to do so as long as it receives power.
When the alarm is unplugged or loses power and you have a good 9 volt battery installed, the alarm will automatically switch to its battery backup mode and you will notice the following:
•After 4 minutes the digital display will show a blinking dot only – this helps conserve the battery’s power.
•The digital display will show a number for CO only if it senses CO while in backup mode.
•If CO is detected while on battery backup, the alarm pattern is con- tinuous quick beeps .
Note: When AC power is restored, the alarm will automatically switch back to normal operating mode.
9