Operating Instructions
NOTE: Before activating the battery carrier tamper resist feature, make sure a fresh battery is installed in the unit and that the battery carrier is properly closed. If the battery carrier tamper resist feature is activated while the battery carrier is open, the battery carrier will not close and the unit will be inoperable during the loss of AC power.
To deactivate the battery carrier tamper resist, in order to change the smoke alarm battery, remove the unit from the trim plate (see Smoke Alarm Tamper Resist Feature if activated), disconnect the AC quick connector and locate the small
CO Alarm Response Time
Never restart the source of a CO problem until it has been fixed. NEVER IGNORE THE ALARM!
The CO sensor meets the alarm response time requirements of UL standard 2034. Standard alarm times are as follows:
At 70 PPM, the unit must alarm within
At 150 PPM, the unit must alarm within
At 400 PPM, the unit must alarm within
This carbon monoxide alarm is designed to detect carbon monoxide gas from ANY source of combus- tion. It is NOT designed to detect any other gas.
Fire Departments, most utility companies and HVAC con- tractors will perform CO inspections, some may charge for this service. It’s advisable to inquire about any applicable fees prior to having the service performed. Kidde will not pay for, or reimburse, the owner or user of this product, for any repair or dispatch calls related to the alarm sounding.
Alarm Removal
IF THE TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER TO TAMPER RESIST FEATURE DESCRIPTION ON PAGE 17 FOR REMOVAL INSTRUCTIONS.
Remove the alarm from the mounting bracket by rotating the alarm in the direction of the “OFF” arrow on the cover.
19
