Installation Instructions
For a
To install:
1.Follow steps 1 through 4 in the previous sec- tion under “To Rotate the Adapter.”
2.With the adapter removed, pull the power cord out of the cord recess, remove the twist tie, and extend the power cord.
3.With the power cord extended, press the last few inches of the power cord back into the cord recess. Gently pull the cord at the bottom of the cord recess until the cord becomes taught and lays flat in cord recess.
4.Carefully replace the back door. Insure the “latches” on all four corners of the door are lined up, then press the door into place.
5.Push with your thumbs in the direction oppo-
Cord
Recess
Back of the alarm when used as a wall mount unit
site of the arrows on the thumb grips and slide the back door toward the top
until it stops. |
|
|
| ||
6. | Mark the location for the two mounting holes on the wall spaced | ||||
vertically 2 5/8" apart. |
|
|
| ||
ALLW | |||||
7. | If you are mounting the alarm in plaster board or | ||||
|
|
| |||
drywall, drill a 3/16" hole into the wall and insert the |
|
|
| ||
plastic anchors provided. Install the two screws provid- |
|
|
| ||
ed into the wall or wall anchors until the screw head |
|
|
| ||
is approximately 1/8" from the wall. |
|
|
| ||
8. | Hook the unit over the screw head and into the |
| 1/8" |
| |
|
| ||||
keyhole in back of the unit. |
|
| |||
9. | Plug the adapter into an unswitched wall socket. |
|
|
| |
|
|
| |||
Table Top Alarm
You can use your Kidde CO alarm as a table top unit. Follow steps 1 thru 4 above under “Wall Mounted Alarm”. Instead of mounting the unit to a wall, pull out the slide support and stand the unit on a table, bedside stand, or chest of draw- ers. (refer to the diagram on page 6).
14
