Operating and Installation Instructions
Step 1: Installing Batteries
Batteries were not installed at the factory and must be installed for the unit to operate! Install the three (3)
AAbatteries in the back of the Smoke/CO Alarm.
•The mounting plate must be removed from the back of the unit to install batteries. To remove, hold the mounting plate and twist counterclockwise (left).
Batteries Must Be Installed in Order Shown Below:
3 | Install |
|
| |
| Last | AA Battery | ALL | |
| THIRD | |||
2 | Install | BEEN VED | NSTALL | |
AA Battery | ||||
| Second | SECOND | ||
|
| WARNING: BATTERIES HA RE |
| |
1 | Install | 1 | INSTALL | |
FIRST | ||||
AA Battery | ||||
| First |
|
|
• The battery polarity markings on the bottom of the battery compartment must be adhered to.
• Batteries must be installed in the sequence shown. If the batteries seem difficult to install, they’re not being installed in the proper sequence.
•Smoke/CO Alarm will not engage to bracket unless all three batteries are installed. Removal of any or all batteries will render the Smoke/CO Alarm inoperative!
•After the batteries are correctly installed the unit will beep once and the red LED light will flash. After
CAUTION: Your Smoke/CO Alarm is sealed and the cover is NOT removable!
8
