Battery Installation/Replacement (cont.)
Battery Installation/Replacement Instructions
To install or replace the batteries in your Kidde unit please perform the following steps:
1.Gently lift open the battery cover to
expose the battery |
|
|
compartment. | TEST/ | MOVE TO |
|
| Carbon Monoxide Alarm |
| RESET | FRESH AIR |
2. Remove the old |
|
|
batteries and |
|
|
properly dispose |
|
|
of them as |
| Figure 4 |
recommended by |
|
the manufacturer (see figure 4).
3.Reinstall the new batteries, being careful to seat the red battery warning flags in the recess of the battery well. Also, note the polarity illustration in the bottom of the battery compartment (see figure 5).
4.The unit will chirp and the green light will flash.
5.Gently close the battery cover. The battery cover of your CO alarm will NOT close if all
three AA batteries are not installed.
Figure 5
What To Do If The Alarm Sounds
Carbon Monoxide Alarm Procedure
WARNING: Actuation of the CO Alarm indicates the presence of Carbon Monoxide (CO) which can kill you.
If alarm signal sounds 4 quick beeps, 5 seconds off:
1)Immediately move to fresh air - outdoors or by an open door or window. Check that all persons are accounted for. Do not
2)Call your emergency local service (fire deptartment or 911).
PHONE NUMBER
Never restart the source of a CO problem until it has been corrected. Never ignore the sound of the alarm!
9 | 10 |