M a i n t e n a n c e
Cleaning the Alarm
The alarm should be cleaned at least once a year.
•To clean your alarm, remove it from the mounting plate as outlined in previous sections. You can clean the alarm by using compressed air or a vacuum cleaner hose with a soft brush attachment. Blow or vacuum around the perimeter of the alarm to remove dust and dirt. The outside of the alarm can be wiped with a damp cloth (do not use a wet cloth to avoid water entering the unit).
•After cleaning, reinstall your alarm and test your alarm by using the Test button. If cleaning does not restore the alarm to normal operation, the alarm should be replaced.
•Do not paint the unit. Paint will seal the vents and interfere with the sensor’s ability to detect smoke. Never attempt to disassemble the unit or clean inside. This action will void your warranty.
Replacing the Alarm
The National Fire Protection Association (NFPA) and Kidde recommend replacing this alarm ten years from the date code label (located on the back of the alarm).
M a i n t e n a n c e
Safety Light
Model 0918CA
NOTE: If the safety light appears dim during regular testing, replace both batteries immediately.
Use only the following 9 volt batteries for powering the safet light:
Alkaline Type | Energizer 522 |
| Duracell MN1604 or MX1604 |
These batteries can be purchased at your local retailer.
The safety light has a 6.3 V 250mA fuse lamp with an average life of 50 hours. If the safety light fails to operate with a fresh alkaline battery, then replace the lamp.
To replace the lamp, remove the alarm from the mounting bracket by rotating the alarm in the direction of the “OFF” arrow on the cover (Image 3D, and Alarm Tamper Resist Feature section if this feature has been activated).
Open the battery door and remove both batteries from the unit. Grip the lamp holder handle with your thumb and finger and pull out the lamp holder assembly. Slide the old lamp out of the lamp holder and replace it with a new lamp.
Replace with the correct lamp type: Vanco #FTB 6 which is available at most radio/tv repair stores.
Reinstall the lamp holder. It will snap easily into the base. Put working batteries back in the alarm and remount the alarm on its mounting bracket.
CAUTION: Use only the lamp specified. Use of a different lamp may have a detrimental effect on the smoke alarm or the safety light operation.
NOTE: The safety light is not intended to satisfy the requirements for approved illumination under various local codes. Very thick and/or dense smoke may obscure the light.
13 | 14 |
