Note: For best results in heavier cutting conditions adjust the deck so the rear of the mower is approximately 2" higher than the front. This method requires less horse- power and ground speeds of approximately
ROTARY MOWER OPERATION
STEP 1
Before each use perform the maintenance described in maintenance section. (page 22)
STEP 2
Read, understand, and follow the information on safety training, preparation, starting and stopping safety, operational safety, transport safety warning sections of this man- ual (pages 11 thru 16)
STEP 3
With tractor running, lower rotary mower into working position.
STEP 4
With the tractor at idle RPM, engage PTO and slowly advance throttle to 540 PTO RPM. NOTE: Rotary mower designed to run at 540 PTO RPM only.
STEP 5
Select a low gear for the tractor and begin to mow. Tractor ground speed is to be controlled by gear selection only and not engine speed. Tractor ground speed should allow rotary mower to maintain 540 PTO RPM and thus maximum blade tip speed.
NOTE: Do not allow the tractor engine or rotary mower to bog down or stall. This causes undue wear and tear on the mower and tractor. If this continues to happen re- duce ground speed and raise cutting height of rotary mower until the 540 PTO RPM is able to be maintained.
Never attempt to clean out a plugged discharge chute until the tractor has been shut down and the mower blades have completely stopped.
STEP 6
After each use clean all debris from the top and bottom of the rotary mower. Re- place any missing or illegible safety decals. Inspect for any damaged or worn parts and replace before next use. Store rotary mower in a dry environment.
21
