\
power supply cord
Move refrigerator close to /5 final position. Remove
. cardboard or plywood from under refrigerator. Plug electrical cord into the grounded outlet. Use the screw from the parts package to install the plug retainer. Move the refrigerator evenly and straight into the opening. Check that the water line will not be kinked. Check that slack in the electrical cord hangs freely behind refrigerator or is placed on top of rehigerator next to cover.
Check that the power switch at the top of the
cabinet is in the “OFF”position.
Flush at least 2 qts. of water through the copper tublng and check for water leaks around the saddle valve. (See page 7 for complete Instructlons.)
refrigerator water valve )
Connect tubing assembly fitting to refrigerator water valve. Do Not overtighten. (It necessary, water valve can be removed from underside of the cabinet to attach the fitting. You may have to remove the wiring channel to get to valve.
leveling rods cl&wise using a 5/l 6” socket and ratchet until the cabinet weight is supported by the rear legs. Use
side/ trim
L
. go to Step 10. Read Side panel requirements, page 6, before attaching.side panels to refrigerator.
/
Remove the screw between coils of water valve. Remove disconnected water valve and attach fitting.
Replace the water valve.)
Slide compression nut and sleeve on open end of tubing assembly fitting. Connect the union from water supply line to compression nut and sleeve on the tubing from water valve and lighten. Do Not overtighten.
Turn water supply valve to the open position. Turn refrigerator switch to the “ON”position. Check all connections for leaks.
Page 10
Open both doors. Place a
18level against the underside n of the door trim at the top of
the refrigerator. Adjust the front leveling legs until level and to the right height for the recessed area. Place the level on the crisper guide in the refrigerator section to check for levelness front to back. Turn the right, rear leveling rod until level and to the required height. Place the level on the freezer basket guide to level the left side of the cabinet.
Remove all tape and door bracing from
refrigerator door. Remove the six screws that attach the handle to the door frame. Slide the refrigerator door panel into door frame. If the panel is less than l/4” thick, a filler panel will need to be installed between the door and decorative panel. If the decorative panel is more than l/4” thick, it will have to be routed to have a l/4” edge on all sides. See Custom panel and insert dimensions for exact sizes to cut custom panels.
