KitchenAid 2000491 Remove two nuts from one end of the top panel frame. Remove end

Remove two nuts from one end of the top panel frame. Remove end

piece. Slide decorative panel into panel frame. Replace end piece using nuts.

Check that (12. top grille is aligned with

top trim on cabinet. Use six1screws to tighten top grille frame to refrigerator. Check that the power switch is in the “ON”position.

Attach top grille decorative panel assembly to the keyhole bracket on the frame and pull down to secure. If the top grille decorative panel does not fit evenly within frame, the keyhole bracket can be moved side to side by adjusting the bracket screws or the decorative panel bracket can be moved up or down by adjusting the decorator panel bracket nuts.

ml Check that doors can

. open freely. If not, the door stops or hinges

can be adjusted.

To adjust horlzontally: Loosen set screw in top and bottom hinges with Allen wrench. Determine the door swing desired. Hold door in that position and tighten the set screws. The doors have stops at 90°, 115’ and 137Opositions. If the door stops cannot be adjusted to clear countertops, the countertops may need to be mitered. (Consult your builder to adjust countertops.)

To adjust vertically: Loosen, do not remove, top and t>ottom hinge screws. Lift door and bottom hinge to desired position. Tighten bottom hinge screws and then top hinge screws.

114Check the water

. connections at the bottom of the refrigerator

again for leaking. Any leaking can cause refrigerator and floor damage.

Open both doors. Use

El two screws to attach bottom grille to cabinet.

Put shelves and bins El I into the refrigerator and

freezer compartments. Remove protective film from door frame.

Move the ice maker arm

(17(. into the down position. Set refrigerator and

freezer compartment controls to the midpoint between “COLD”and “COLDEST”. Check that the compressor is operating properly. Check that all five interior lights and one exterior light above dispenser area are working.

118Use a drinking glass to n press ice dispenser bar.

You should hear the motor and auger operating. Press the glass against the water dispenser bar. Dispense and discard about 2 to 3-quarts of water

.to remove air from system and rinse tank.

To get the most efficient use from your new built-in refrigerator, read your KitchenAid Use and Care Guide. Keep Ins talla tion Ins true tions and Guide close to built-in refrigerator for easy reference.

Page 11