Product dimensions +/- I/W tolerance
- | 42” - |
protruding door inslallalion
doors | side trim |
Refrigerator
+- l/4”
5/32”+
19132”
4
Side trim
spacers
1.Attach three spacers from the miscellaneous parts bag to the top, middle and bottom of each side of the refrigerator. Spacers are required for ventilation.
side panel support nailer
b
I
25”
2.A side panel support nailer should be attached to the rear wall on each side of refrigerator
when 25” depth is available. If less than 25” depth is available, go to step 3.
If side panel is not inserted into side trim, drill six
Side panel thickness should be l/2” minimum to prevent “blousing” or warping.
side panel support nailer
112” side panel recommended
3.If less than 25” depth is available, side panel installation will need to be
completed according to each site’s restrictions.
One method is to attach side panel to outside of side trim. However, this will increase width required. Drill holes into side trim. Attach a wood.suppon to side trim. Attach side panel to panel support nailer and wood support. Cover wood support with a panel piece to match side panel.
notches for door hinges
toe panel recess ,/
4.Height of side panels depends on your installation site. Side panels may need to be notched to clear door hinges. Side panels may be cut to match toe panel recess if desired.
Notch side panel only after the installed height of the refrigerator has been determined.
Page 6