KitchenAid 2000495 installation instructions “Iii

3-prong aroundina tvDe

retainer

Move refrigerator close to

15final position. Remove

. cardboard or plywood from under refrigerator. Plug electrical cord inio the grounded outlet. Use the screw from the parts package to install the plug retainer. Move the refrigerator evenly and straight into the opening. Check that the water line will not be kinked. Check that slack in the electrical cord hangs freely behind refrigerator or is placed on top of refrigerator next to cover.

/7 Remove tape from rear

n leveling rods. Turn the two leveling rods clockwise using a 5/l 6” socket and ratchet until the cabinet weight is supported by the rear legs. Use l-3/8” open end wrench to lower the front leveling legs until the weight of the cabinet is supported by legs.

I-1

19 If side panels are not used,

. go to Step 10. Read Side panel requirements, page 6, before attaching side panels to refregerator.

\\ \\

16. Check that the power switch at the top of the

cabinet is in the “OFF” position.

Flush at least 2 qts. of water
through the copper tubing and
check for water leaks around the
saddle valve. (See page 7 for
complete	Instructions.)			-
refrigerator	waler	valve			I!=
			- ..	“III
compresslon	nut	sleeve

Connect tubing assembly fitting to refrigerator water valve. Do Not over-tighten. (if necessary, water valve can be removed from underside of the cabinet to attach the fitting. You may have to remove the wiring channel to get to valve. Remove the screw between coils of water valve. Remove disconnected water valve and attach fitting. Replace the water valve.)

Slide compression nut and sleeve on open end of tubing assembly fitting. Connect the union from water supply line to compression nut and sleeve on the tubing from water valve and tighten. Do Not over-tighten.

Turn water supply valve to the open position. Turn refrigerator switch to the “ON”position. Check all connections for leaks.

Page 10

Open both doors. Place a El level against the underside

n of the door trim at the top of the refrigerator. Adjust the front leveling legs until level and to the right height for the recessed area. Place the level on the crisper guide in the refrigerator section to check for levelness front to back. Turn the right, rear leveling rod until level and to the required height. Place the level on the freezer basket guide to level the left side of the cabinet.

Remove all tape and door bracing from

refrigerator door. Remove the six screws that attach the handle to the door frame. Slide the refrigerator door panel into door frame. If the panel is less than l/4” thick, a filler panel will need to be installed between the door and decorative panel. if the decorative panel is more than l/4” thick, it will have to be routed to have a l/4” edge on all sides. See Custom panel and inset-l dimensions for exact sizes to cut custom panels.