KitchenAid 2209478 manual Built-in opening requirements & dimensions, Opening dimensions

Built-in opening requirements & dimensions

All dimensions ±1/8" (3 mm)

*If solid soffit is not available, see “Anti-tip requirements” on Page 4. One of the three methods shown must be used.

The built-in refrigerator can be installed:

•recessed in the cabinet opening.

•at the end of cabinets using a side panel to enclose the refrigerator side.

Select one method and use dimensions given. Dimensions shown provide 0" (0 cm) clearance.

Mark stud

locations on

rear wall

80" - 90"

(203-229 cm)

above floor.

7"

(18 cm)

Grounded electrical

outlet location

Grounded electrical

outlet is required.

83-1/4” (211.5 cm) min.

84-3/4” (215 cm) max.

to bottom of solid soffit.*

If optional side panel is used,

install support board on rear

77"

wall if opening depth is

(196 cm)

25" (63.5 cm) or more.

Width

Water line must

Water line

provide 15-100 psi

location can be

(103-690 kPa) water

through floor

pressure. Rough in

or wall.*

6"

water line before

(15.2 cm)

installing

refrigerator.

6" (15.2 cm)

3" (7.6 cm)

The water hookup connection may be located in the base cabinet on either side of the refrigerator. The right hand side is recommended.*

Note: The access hole through the cabinet must be within 1/2” (12.7 mm) of rear wall.

23-1/2”

11"

(28 cm)

(60 cm) min.

6"		6"
(15.2 cm)	(15.2 cm)

1/2" (12 mm) hole for plumbing	Floor: Must support refrigerator,
can be located anywhere within	contents, and door panels.
shaded area.

*If a recommended water line location is used, no additional plumbing needs to be purchased.

Opening dimensions

Model	36" (91 cm)	42" (106 cm)	48" (122 cm)
Width min.	35-1/2" (90 cm)	41-1/2" (105 cm)	47-1/2" (120 cm)

Page 3