top grille assembly
decorative panel
assembly
15.Wraparound metal door models: go to step 17.
Panel models: Slide decorative panel assembly up to remove from top grille assembly.
remove 2
screws
top grille decorative panel
16. Panel models: Remove screws and side trim from one side of the decorative panel. Insert your panel. Reattach side trim and screws.
cabinet
cabinet grille panel side trim side trim
grille panel | louver | |
assembly | ||
screws | ||
|
17. Panel models: Slide decorative panel down to reattach to top grille.
18. If side panels are not used,
Top view
rear wall
support board
A
side panel
B
side trim door
| Panel | Wraparound |
| models (shown) | metal |
|
| door models |
A | 24" | 23" |
| (61 cm) | (58.4 cm) |
B | ||
| (62.5 cm max.) | (59.4 cm) |
•Inside side trim piece: Slide front edge of routed side panel into trim piece. Nail rear edge of panel to support board.
NOTE: KitchenAid is not responsible for the removal or addition of molding or decorative panels that would prevent the refrigerator from being serviced.
19. Open refrigerator doors and remove protective film from door frame. Recheck water connections at bottom of refrigerator for leaks.
Install shelves and bins in refrigerator and freezer compartments.
20. Remove the grille and skirt package taped to front of refrigerator. Remove grille and skirt and 2 screws from package.
refrigerator cabinet
bottom
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
floor |
|
|
|
|
| measure this | ||
|
|
|
|
|
|
| distance | |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
measured distance
grille and skirt assembly (from step 21)
score "V" groove
22. Measure this same distance from the top of the bottom grille to the closest "V" groove on the grille skirt.
Use a knife to score down the "V" groove and break skirt at the score line.
screws |
grille and
skirt assembly
23. Attach the bottom grille and skirt assembly to the cabinet with the 2 screws.
24. Set refrigerator and freezer compartment controls to the midpoint between “COLD” and “COLDEST.” Check that the compressor is operating properly and that all five lights are working.
To get the most efficient use from your new
go to Step 19.
If
(63.5 cm) or more, side panels can be installed inside the side trim or attached to the outside of the side trim.
21. Open refrigerator door and | Note: If construction will continue after | |
refrigerator is installed, rotate control in | ||
freezer compartment counterclockwise | ||
measure the distance from the bottom | to the “OFF” position. | |
of refrigerator cabinet to the floor. | ||
|
Page 11
