KitchenAid 2210725 manual Plug in refrigerator, Level refrigerator, Style, Page

Style 2

bulb

nut

(provided)

Push the bulb end of the tubing into the water valve as far as it will go. Slide the nut forward and finger tighten. Tighten nut two

(2) more turns with wrench.

Plug in

refrigerator.

grounded

outlet

7. Plug power supply cord into grounded outlet.

power supply cord

8.Move refrigerator into final position.

This refrigerator has 4 adjustable rollers (2 front and 2 rear). There are 2 sets of roller adjusting bolts found at the base of the refrigerator on each side. The yellow top bolt will adjust the rear roller and the silver bottom bolt will adjust the front roller.

rear

adjusting

bolt

(yellow)

front

adjusting

bolt

(silver)

10.Use a 1/2" socket wrench to turn the roller adjusting bolts. Turning the bolt clockwise will raise the refrigerator and counterclockwise will lower the refrigerator. (NOTE: Be careful not to back the roller bolts out of the roller brackets when lowering the refrigerator. The bolt head will start to back out toward you when the roller is in its lowest position. If the screw does come out of the rear roller bracket, the compartment access cover on the back of the refrigerator will have to be removed to reinstall the bolt back into the nut.)

13.If desired, the 4 rollers may now be raised to close the gap between the refrigerator top hinge and the cabinet opening. Check that all 4 rollers contact the floor and the cabinet doors above the refrigerator open fully.

3/4" (19 mm) clearance set for

full-overlay cabinetcabinet doors and

refrigerator trim kit

NOTE: Cabinets with full-overlay doors will require 1/4" (6 mm) additional clearance between the top hinge and cabinet to prevent the doors from hitting the hinge when opening. (If you have a trim/panel kit on the refrigerator doors, 3/4" (19 mm) additional clearance will be required to prevent the cabinet doors from interfering with the refrigerator door trims.)

14.Replace the base grille.

• Open the refrigerator doors to 90°.

Style 1: Screw-on grille

Level refrigerator.

9. Remove base grille if it is installed.

• Open the refrigerator doors to 90°.

Style 1: Screw-on grille

1/8" (3 mm) clearance for leveling refrigerator

1/4" (6 mm) clearance set for full-overlay cabinet doors

cabinet

•Place the grille in front of the base grille area.

•Use a Phillips screwdriver and guide the screws through the grille holes and into the screw clips located in the corner plates on each side of the opening. Tighten screws securely.

•Find pockets located about 4 inches

(10 cm) in from each end of grille. Use Phillips screwdriver to remove the screw found in each pocket.

Do Not remove the Tech Sheets fastened behind the grille.

Style 2: Snap-on grille

•Grasp the grille with both hands. Lift up and tilt the top of the grill toward you.

Do Not remove the Tech Sheets fastened behind the grille.

The roller adjusting bolts are located behind the base grille.

11.Adjust the front rollers to bring the refrigerator top parallel with the cabinet above the refrigerator; leave about 1/8"

(3 mm) gap between the refrigerator top hinge and the cabinet. (If you do not have a cabinet above the refrigerator, adjust to make the top level.)

12.Adjust the rear bolts to bring the refrigerator level with the side cabinets or cabinet end panels.

Style 2: Snap-on grille

•Place the grille lower clips into the holes in the refrigerator panel. Roll the grille up toward the refrigerator until it snaps into place.

Page 6