KitchenAid 2225033A Base Grille, Refrigerator Doors, Connecting to Refrigerator, Handle Removal

Models: 12642708SP 2225033A

1 40
Download 40 pages 31.66 Kb
Page 6
Image 6
Connecting to Refrigerator

7.Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing into a bucket or sink. Turn ON main water supply and flush out tubing until water is clear. Turn OFF shutoff valve on the water pipe. Check for leaks. Coil copper tubing.

Connecting to Refrigerator

1.Remove plastic cap from water valve inlet port. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on copper tubing.

2.Create a service loop using extreme care to avoid kinks. Secure copper tubing to refrigerator cabinet with a “P” clamp.

1

2

3

4

5

1.Copper Tubing

2.“P” Clamp

3.Compression Nut

4.Compression Sleeve

5.Water Valve Inlet Port

3.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

4.Plug in refrigerator or reconnect power.

5.Push refrigerator into opening.

Base Grille

Removing the base grille

1.Grasp the grille with both hands.

2.Pull up on the bottom and tilt it toward you.

3.Pull down to release the top of the grille.

Replacing the base grille

1.See markings on inside of base grille for proper placement.

2.Snap the top of the grille into place first.

3.Press down and in on the bottom of the grille until it snaps into place.

Refrigerator Doors

Handle Removal

(Graphics are included later in this section.)

1.Using a ³⁄₃₂ in. Allen wrench, loosen the 2 set screws located on the side of each handle.

2.Pull handle straight out from the door. Make sure you keep screws for reattaching handles.

Freezer Drawer Removal

(Graphics are included later in this section.)

1.Open freezer drawer to full extension.

2.Remove all articles from baskets.

3.Slide top wire basket out to full extension and lift out to remove.

4.Remove the bottom wire basket by pressing the release button on each side and lifting the basket from the rail guides.

1

1. Release button

6

Page 6
Image 6
KitchenAid 2225033A Base Grille, Refrigerator Doors, Connecting to Refrigerator, Removing the base grille, Handle Removal