3.Remove the handle side and top trims.
A A
AdjustDoors
Door Height Adjustment
Use the following steps to adjust the door height, up or down, after the doors have been leveled.
1. Open the freezer or refrigerator door. Locate the bottom hinge and remove the door stop screw.
Classic and Architect® Models
Remove the door stop screw from the bottom side of the hinge with a ³⁄₈" open end wrench.
A.Trims
4.Slide the custom panels into the bottom and hinge side trims on the refrigerator compartment and freezer compartment doors, making sure that the backer panel fits into the hinge side trims.
AA
A.Panels
5.Reinstall the
6.Remove the protective skin from the screw covers. Slide or snap the screw covers into the handle trim section.
7.Check refrigerator level and alignment. Adjust if needed.
AB C
A.Bushing
B.Door stop screw
C.Locking plate
Overlay Models
Remove the two door stop screws: one from the bottom side using a ³⁄₈" open end wrench and one from the top side using a ⁵⁄₃₂" Allen wrench.
AB
A.Door stop screw from bottom
B.Door stop screw from top (110°)
2.Remove the locking plate as shown.
3.Turn the bushing located underneath the bottom of the hinge using a ¹⁄₂" open end wrench. Turning the bushing to the left (counterclockwise) will raise the door. Turning the bushing right (clockwise) will lower the door.
24