KitchenAid 253 warranty n Press the ON/OFF switch figure

nClose the filter holder and make sure that it is completely closed (figure 7).

Set the carafe lid on the carafe, and replace the carafe on the warming plate.

nPress the ON/OFF switch (figure 8).

A red indicator light will illuminate and brewing will commence.

CAUTION: Never open the filter holder during the brewing process.

nThis model features a full flavor selector button. If you want to make l-3 cups of coffee, press the flavor selector button (figure 9).

A yellow indicator light will illuminate. This will extend the brewing cycle so that the water will seep into the ground coffee slowly enough to yield brewed coffee that is rich, aromatic and truly delicious.

The flavor selector button is automatically switched off when the appliance shuts off.

Remove the glass carafe when the brewing process is completed and serve.

nReplace the carafe on the warming plate to keep it hot (figure 10).

The “Stop’n Serve” feature is KRUPS answer to the impatient coffee drinker’s clamor for “a quick cup of coffee!“ This device automatically stops the flow of brewed coffee through the filter cone if the glass carafe is removed from the warming plate during the brewing cycle. You have about 20 seconds between the removal of the carafe and its being reinserted to allow the service of one or two cups of coffee. The “Stop’n Serve” device closes off the filter cone

so effectively that there is virtually no coffee-drip onto the warming plate (one drop, at most). Once the carafe is replaced, the brewing cycle and the flow of coffee into the carafe are resumed.

CAUTION:

If coffee does drip onto the warming plate after removal of the carafe, it is usually an indication that too much ground coffee has been placed into the paper filter. This causes the water that jets into the filter cone to overflow between the paper filter and the sides of the filter cone. The overflow carries coffee grounds that interfere with the snap-shut action of the filter holder, thus allowing brewed coffee to continue to drip through.

If this blockage and subsequent dripping do occur, replace the glass carafe immediately and allow the full brewing cycle to run its course. Do not remove the filter until the brewing cycle is completed.

The KRUPS “Premium” is equipped with an automatic shut-off feature, that will turn off the machine 2 hours after the brewing process has begun (the red indicator light will turn off).

The appliance can be switched off manually at any time, however, by using the ON/OFF switch.

WThe power cord can be tailored to the length required by utilising the hidden cord storage located behind the coffeemaker (figure 11).

9