Maintenance
Replacing the light bulb:
This range hood uses fluorescent lamp type
Remove the retainer clips from both ends of the light cover. Carefully slide the cover all the way to the right. Then lower the left end of the glass below the support flange and remove the glass by sliding it back from the left.
Install a new fluorescent light bulb.
Position the right end of the light cover over the flange and slide the cover all the way to the right. Position the left end of the light cover over the flange and slide the cover back to left. Reinstall the retainer clips.
Wiring diagram
retainer clips
support flange
For assistance:
If you have questions about operating, cleaning or maintaining your range hood:
Call the KitchenAid Consumer Assistance Center,
If you need service:
Maintain the quality built into your appliance by calling a KitchenAid- authorized service company. To obtain the name and number of an authorized service company:
Contact the dealer from whom you purchased the appliance;
Look in the Yellow Pages of your telephone directory under “Appliances
— Household — Major — Service and Repair;”
Call the KitchenAid Consumer Assistance Center,
Accessories
available from your dealer
Note: Instructions are included with each kit.
Backsplash*: Must be installed before hood is installed. Stainless steel only.
Part No. 8171295 30" (76.2 cm) Part No. 4378615 36" (91.4 cm) Part No. 8171296 48" (121.9 cm)
Utensil Bar: Stainless steel only Part No. 4378619 (side)
15" (38 cm) long
Part No. 8171299 (back) 30" (76 cm) long
Part No. 4378618 (back)
Charcoal Filters:
Part No. 4378623 (2 per pkg.)
Part No. 8171290 (biscuit) Wire Rack: Chrome only
Part No. 8171297 30" (76.2 cm) Part No. 4378616 36" (91.4 cm) Part No. 8171298 48" (121.9 cm)
Rack Hanger Kit: Chrome only Part No. 4378617
Chimney Extensions*:
Part No. 8171313 (stainless steel) Part No. 8171315 (biscuit)
Part No. 8171314 (white) *These instructions must be read
before starting the canopy hood installation.
9
