Check operation
16. Place filters in canopy open- ings so rear edge is over flange. Press filters up into position.
17. Turn power on.
control panel
location
18. The canopy hood controls are located in a grey panel on underside of the canopy. To open the panel, press on the front edge of panel and release. The control panel will drop down.
light | blower | blower speed |
switch | switch | switch |
19. Check the operation of the range hood:
Move light switch to “1” position. The light should turn on.
Move blower switch to “1” position. The blower should operate.
Move the blower speed switch to the far left; blower speed should be LOW. Move blower speed to right; blower speed should gradually increase until you reach HIGH speed at far right.
Move blower and light switches to “0” position to turn blower and light off.
If range hood does not operate:
Check that the circuit breaker is not tripped or the house fuse blown.
Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read the “Use and Care Information” section.
Keep your KitchenAid
Installation Instructions and Use and Care Guide close to range hood for easy reference.
7
