KitchenAid 3KUIS185V Changing TI-IE BIN Door and Lower Panel, Shipboard Operation, Dimensions

	CHANGING TI-IE BIN DOOR AND LOWER PANEL
The	slorage	bin door	and lower	panel	are deslgned	to	DOORBIN
								LOWER
								PANEL
accept an		oplional	decorative	wood	panel of your
choice.
The	wood	panel should	be no more than		j/4 Inch (6.35	mm)	Tf
							11 %”	11’%8”	PANEL
Ihick. GUI il lo the same size as Ihe production							I(28.6 cm)	(30.3 cm:
									DIMENSIONS
panel.	See	Figure 1.

To change the bin door panel.

1.Open the bin door.

2.	Remove	the	two screws on lop of the door which	b(43.2	cm)-
	hold Ihe	handle.
3.	Remove	the	handle.	FIGURE	1

4.Slide the metal panels out.

5.Break off the ribs on the door insulalion to allow

for the wood thickness. See Figure 2

6.Slide the wood panel into the door frame.

7.Replace handle and acraws.

To change the lower panel:

-

1.Hemwe the two screws at the txttom that hold the

lower	panel	assembly	to	the	ice	maker	REMOVE	ALL DOOR INSULATION
							RIBS TO	ACCEPT	WOOD PANEL
2. Remove	the	Iwo acraws		on	the	top of the pane!	THICKNESS
assembly.
								FIGURE	2

3.Slide the metal panels and spacers 01~1.

4.Slide the wood panel into Ihe door frame.

5.Replace the top of the panel assembly

NOTE: Make sure the galvanized panel is replaced I” back of the panel assembly.

If ice maker is installed above two thousand feet of

altitude, the bin and evaporator thermostats must

be adjusted to a warmer setting. Disconnect

electricity, remove thermostat and follow the

directions for turning the altitude adjustment screw as shown in the label on each thermostat.

SHIPBOARD OPERATION

When this ice cube maker is installed aboard a ship, it will be necessary to purchase and install a water

deflector. This deflector hanas between the lower

edge of the evaporator and the cutter grid. It keeps

the water flowing over the evaporator from spilling into the storage bin area. Order the necessary parts from your local ice maker dealer.

2